Pirate 4x4 banner
1 - 15 of 15 Posts

SAS_Tacoma

· Registered
Joined
·
112 Posts
Discussion starter · #1 ·
Well, I have come to the conclusion I need to get rid of 1 taco and just build a buggy. Well here is the deal I am selling my sas truck.
Details for ya:
-1997 STD 2.7 Tacoma
-SAS
-rebuilt dana 44 waggy axle.(new bearings, seals, gears)
-NEW lock-rite upfront
-welded rear
-pioneer cd player.
-doors are removable. i have welded in safety doors like a jeep, but -a 1 hour work session could remove them.
-rs 44044 front springs- like 9 month old
-63 inch chevy rear springs.
-custom flat bed
-22 gallon summit fuel cell
-alum box built into bed
-sweet ass front bumper(i want to put it on my daily driver soooo bad
-2 spare axles per side(front only) with new spicer 760x joints
-i am keepsing the alum rims and tire(unless you want to buy them)
-2 inch 1/4 thick roll bar with spare carrier
-super strong battery holder
-6 inch shackles front and rear
-new alternator, clutch, bearings, lots of crap NEW NEW NEW
-bucket seats
-cb with cb antenna for the radio so they match...
-full sliders all the way around
-high-angle d-shafts all over the place-new u-joint here too
-4.88 gears
-new wipers
-all stains will be sold as is, coffee cups don't like rocks.
-dual kick ass fans, if you get stuck turn them on...
-front and rear winch mounts
-d-rings all over

Come on people I have listed about every stupid thing I have updated on my truck, I can't even remember all the stuff I have on it.

Price you say: I want 6000.00, but I am low on time and money and all the other stuff in life. $5000.00 is as low as I will go. The taco itself has 112,000 miles on it. I will toss in any spare Taco parts I can( 2 trannies missing 5th gears, manifold(NO CRACK), some seals and bearings)

EVERYTHING IS FOR SALE, if you want a tranny email me a price, If you want the manifold ask, whatever I GOT LOTS OF CRAP AND NO PLACE OR DESIRE FOR IT.

I will meet you anywhere in the USA half way, all you gotta pay is fuel for my hauler(diesel flatbed, 14 miles to the gallon) and road tolls that I accumulate.

EMAIL IMASAUSAGE@H0T****.C0M
AIM SAUSAGEMC

Location: Pittsburgh PA
Price: $5000.00
delivery avaliable at cost
mud and rocks are free.
 

Attachments

Save
Front Drive Shaft

You wouldnt happen to have a factory front driveshaft would you?

If you do $25 and I will pay the shipping.
 
Save
Okay checked out the pics, so it is 5,000 minus wheels and tires, Does this have a clean title or is it salvaged, does it have dual cases or hy-steer. It looked like in the photo is does have Hy-Steer hard to tell though.
 
Save
Discussion starter · #11 ·
DBrown2 said:
Okay checked out the pics, so it is 5,000 minus wheels and tires, Does this have a clean title or is it salvaged, does it have dual cases or hy-steer. It looked like in the photo is does have Hy-Steer hard to tell though.
well yes it has hy-steer, the title is perfect, i used to drive the truck to college then i just kept getting bigger with it...

i am about to toss the 1000 worth of tires in cause the engine is running, but it got a water shot and i think the valves in number 3 are ticking.

i found a motor for 700 so i may have to put that in before i sell it. or 5000 the way it is...

no dual case., 4.88 gears with factory 2.27:1 low range is it...
 
Save
SAS_Tacoma said:


why take the axle out of a running complete rig. dumb question..

however i am able to locate dana 44's if you need one.
Well you are a dumb ass, it says it right under your name :flipoff2:
Thought I saw where you were parting out on another board sorry. I PMed you.
 
1 - 15 of 15 Posts
You have insufficient privileges to reply here.