Pirate 4x4 banner
1 - 14 of 14 Posts

Dusty Booger

· Registered
Joined
·
1,381 Posts
Discussion starter · #1 · (Edited)
Specs are as follows: 1957 w/ 1976 tub & frame.
SMOG EXEMPT!

AXLES
30 spline Dana 44's front & rear w/ 4.10 gears. Full Detroit Soft Locker in rear, Detroit EZ Locker front. Chevy power disc brakes up front w/ Ford hub & rotor (5 x 5.5") HD Alloy DOM tie rod & drag link.

ENGINE
AMC 360 w/ Edelbrock intake & carb. Has cam & headers as well- This Jeep is super fast & great for dunes. Must hear this engine run!
Has heavy duty MORE motor mounts
Runs a Holley Electric Fuel pump.

TRANS & T-CASE
T18 transmission w/ Mcleod clutch.
Dana 20- recently rebuilt. Course spline output shafts replaced with late model 20 fine spline shafts.
1310 yokes with CV drivelines front & rear.

SUSPENSION
4" Procomp springs. Front upgraded to 2.5" springs
Rear u-bolt flip kit for greater clearance
33" mud tires - good tread (No spare)
15 x 10 aluminum rims - Also have AR767's 15 x 8 if prefer

OTHER
Warn 8000# winch w/ mounting plate
Power steering
Custom tubular crossmember/skidplate
Aluminum dash w/ Autometer guages
20 Gallon CJ7 fuel tank.
Currie steering brace
Supertop in good condition
Tuffy Security glove box
Yorx on board air compressor mounted but not wired.

WHAT IT NEEDS
Should be painted + some body work- dents, dings & holes drilled for old roll bar etc. (NO RUST)
Have brand new CJ windshield - Needs glass
(Jeep currently has YJ windshield & glass that I have been running
for last couple years.)
Fuel guage not working correctly - may be sending unit.

*$5500 OBO - Come check it out in Livermore. Cell 510-502-8508
*New price!

Scott

E-mail me at scottdwatkins2000 for pic requests
Thanks
 
Discussion starter · #3 ·
I have way more than $6500 invested in this Jeep. It has been through Rubicon & Fordyce. It is one of the most fun Jeeps I have ever owned. It is super fast - awsome at the dunes. Check it out and make an offer!
 
Discussion starter · #12 ·
TTT - Nobody wants a cheap good wheeler. Why buy a $2500 POS and sink in $10K. You can pick this one up cheap. It would only need a little TLC & some paint - Maybe a $1-2K worth or work to be a cherry rig.
 
1 - 14 of 14 Posts
You have insufficient privileges to reply here.