Up for sale again.. But now improved even more I want it gone now.. Smoking deal.. Smog is good for another few weeks ..come and get it $7900 or part trade for ?
http://s259.photobucket.com/albums/hh309/pat4x44wd/Runner build/
axle build thread http://www.pirate4x4.com/forum/showthread.php?t=654231
Custom built Wider toyota frontend, 61.5" wide, chrome molly 4340 custom shaft, HS Vented rotors, all new bearings and seals, wheel and trunions, felts
Front HP elocker.. Was NEW when installed a couple weeks ago.. not used.. 4.10's.. 12volt guy wiring
60" wide taco elocker rear end 50,000 miles, 12volt guy wiring kit
1999 3.4 motor out of 99 runner, 90,000 miles.. runs PERFECT in everyway
Just got it certified by the ca State smog ref.. Ran Super clean, smog REF said it looked like a factory install
Downey headers
New exaust with flowmaster and new cat
SAS with 44044's in the front
trail gear 5 inch springs in the rear
Bilstiens all 4 corners
marlin sliders
optima
New 35 BFG muds on 2 inch BS 15x8's
5speed r150f and chain case
Front driveshaft squareshaft
Stainless brakelines
Cold AC
Clean interior
Cleanbody, small ding on tailgate
All power doors, windows, mirrors work perfect
Downey Intake
Cobra CD
Sunroof, works perfect
Not much bad but it has a crack in the windsheild, a couple in the dash, SLIGHT vibe from rear shaft at freeway speed(nothing a cv would not fix) and I would change out the square front to a standard long travel at some point since I hate hearing the square make noise when the hubs are in..
this runner runs perfect, Drives great on the road for a lifted 4x4.. Great family wheeler.. I Might Trade for something plus cash ..What you got, Looking for some thing to play with for a while and sell later. There is more, I will post it as I think of it.. $7900.00 firm or the part trade with Cash
530 370 6991
http://s259.photobucket.com/albums/hh309/pat4x44wd/Runner build/
axle build thread http://www.pirate4x4.com/forum/showthread.php?t=654231
Custom built Wider toyota frontend, 61.5" wide, chrome molly 4340 custom shaft, HS Vented rotors, all new bearings and seals, wheel and trunions, felts
Front HP elocker.. Was NEW when installed a couple weeks ago.. not used.. 4.10's.. 12volt guy wiring
60" wide taco elocker rear end 50,000 miles, 12volt guy wiring kit
1999 3.4 motor out of 99 runner, 90,000 miles.. runs PERFECT in everyway
Just got it certified by the ca State smog ref.. Ran Super clean, smog REF said it looked like a factory install
Downey headers
New exaust with flowmaster and new cat
SAS with 44044's in the front
trail gear 5 inch springs in the rear
Bilstiens all 4 corners
marlin sliders
optima
New 35 BFG muds on 2 inch BS 15x8's
5speed r150f and chain case
Front driveshaft squareshaft
Stainless brakelines
Cold AC
Clean interior
Cleanbody, small ding on tailgate
All power doors, windows, mirrors work perfect
Downey Intake
Cobra CD
Sunroof, works perfect
Not much bad but it has a crack in the windsheild, a couple in the dash, SLIGHT vibe from rear shaft at freeway speed(nothing a cv would not fix) and I would change out the square front to a standard long travel at some point since I hate hearing the square make noise when the hubs are in..
this runner runs perfect, Drives great on the road for a lifted 4x4.. Great family wheeler.. I Might Trade for something plus cash ..What you got, Looking for some thing to play with for a while and sell later. There is more, I will post it as I think of it.. $7900.00 firm or the part trade with Cash
530 370 6991
